215A.5 - MARKING WITH SEAL.

        215A.5  MARKING WITH SEAL.
         If an inspection or comparative test reveals that the
      moisture-measuring device being inspected or tested conforms to the
      standards and specifications established by the department, the
      department shall cause the same to be marked with an appropriate
      seal.  Any moisture-measuring device which upon inspection is found
      not to conform with the specifications and standards established by
      the department shall be marked with an appropriate seal showing such
      device to be defective, which seal shall not be altered or removed
      until said moisture-measuring device is properly repaired and
      reinspected.  The owner or user of such device shall be notified of
      such defective condition by the department or its properly designated
      employees on an inspection form prepared by the department.  
         Section History: Early Form
         [C71, 73, 75, 77, 79, 81, § 215A.5]
         Referred to in § 215A.6, 215A.9